What is the procedure to configure bridge mode on the LTE3316?
Step by step guide:
1. Either connect your computer directly to one of the LAN ports of the LTE3316 or connect to the pre-configured WiFi (SSID and PSK are stated on the back of the device)
2. Login to the routers default IP 192.168.1.1 using the default credentials admin/1234
3. Go to Configuration > Network > WAN > WAN Management > WAN-1 > Action
4. Enable Bridge Mode on the bottom of the page.
Here you have two possibilities:
with Fixed MAC: only your specified MAC gets the WAN IP from the ISP
without Fixed MAC: only your first connected device will get the WAN IP from the ISP
Test the result:
Check if you device got the bridged IP.
If it was correctly configured it will have the WAN IP from the ISP.