Firmware 5.10 - ATP and USG FLEX on Cloud New Management Wizard

This article will have a Look at the New Installation Wizard under the New Firmware 5.10 and higher for our ATP and USG FLEX Series.

1. Initial Setup Wizard: Select Management Mode
2. On-Premise
3. Nebula Cloud

Initial Setup Wizard: Select Management Mode

When you log into the Web Configurator for the first time or reset the Zyxel Device to its default configuration, the Initial Setup Wizard screen displays.

This wizard helps you configuring Internet connection settings and activate subscription services.
Note:
For Zyxel Devices that already have firmware version 4.25 or later, you have to register your Zyxel Device and activate the corresponding service at myZyxel (through your Zyxel Device).
• Click the double arrow in the upper right corner to display or hide the help.
• Click Logout to exit the Initial Setup Wizard or click Next to continue the wizard. Click Finish at the end of the wizard to complete the wizard.

On-Premise

Select On-Premises Mode to manage your Zyxel Device using the Web Configurator or the Command Line Interface (CLI).

Use this mode to secure your networks with the Zyxel Device security services.

Follow the On-Premises mode wizard to set up your Zyxel Device, such as configuring the WAN settings, registering your Zyxel Device and allowing remote access to your Zyxel Device.

Nebula Cloud

Select Nebula Mode to manage your Zyxel Device using Nebula Control Center (NCC).

NCC is a cloud-based network management system that allows you to manage and monitor your Zyxel Device remotely.

Use this mode to manage your Zyxel Device with accounts at different privilege levels.

You can also manage your Zyxel Device licenses and status through NCC.

Follow the Nebula mode wizard to configure the WAN settings to pass the management of your Zyxel Device to NCC.
Note:
You need to press the reset button to change the Zyxel Device mode once you finish the wizard.

If you reset the Zyxel Device through the web configurator or the CLI, you will not see this screen.