This article will look at how connect the DX3301-T0 on a DSL Line and VoIP

Note! Please get the information below by calling your internet service provider.

On the DX3301, you can configure your new router's internet connection in only 2 steps: 

1. Configure SIP Account

2. Configure Internet Connection (Broadband / DSL / PPPoE)

1. Configure SIP Account

Note! The VoIP works only when 802.1p is set to Prio 5.

For VoIP, we need to add a SIP Account. Click on the left symbol below "Modify" to modify the Account settings:

Click on the checkbox to enable SIP Account, then enter your SIP account number, username & password, URL type, and the Voice features. Please contact your internet provider (ISP) to get the information below:

Next, we need to define the Provider Profile. Click on the left button below modify to modify the Service Provider:

Make sure the SIP Service Provider is enabled and enter the SIP Service provider information. Please contact your internet provider (ISP) to get the information below:

Then we activate the registration and should see the status as registered. Click on the "flip-switch" to Register Action and then the "Registration" should state "Registered"

2. Configure Internet Connection (Broadband / DSL / PPPoE)

Note! PPPoE only works when Broadband Profile with 802.1q VLAN ID 7 is used.

Navigate to Broadband and click on the left button below "Modify" to modify the internet connection settings:

Select the Mode to "routing" if you want to have the router as a router.

Choose the Encapsulation to the internet connection you're having (e.g. PPPoE)

The IPv4/IPv6 Mode, PPP information (PPPoE account settings)

The VLAN (if needed)

MTU size (for PPPoE usually is 1492)

IP Address (set to static IP or DHCP)

Please contact your internet provider (ISP) to get the information.

Please see the table below for a more detailed view of the priorities for Data and Voice (VoIP) Services: