First setup of your firewall - USG / FLEX / VPN / ATP

Created November 30, 2021 12:11 - Updated August 28, 2024 10:04

Serhii Boiarynov

In this article we are going to go through the first setup of the firewall, this article will not include any deep configuration. At the bottom of the article, you will find a list of helpful next steps in terms of configuration.

Before starting, ensure that you have connected your WAN cable and LAN cable.

1. Logging in to the web GUI of the device

You can access the device with https://192.168.1.1/ by default.

The default credentials are below to log in to the device:

Username: admin 
Password: 1234

You will be prompted to change the password before you can log in again, please memorize this or save the password so you don't forget it.

2. Setup wizard walkthrough

When you have logged in for the first time you will be presented with the setup wizard, this will guide you with the basic system settings for the device, such as time and date, internet, device registration, etc.

For convenience for management, you might want to enable remote access to the firewall over the internet, and for security reasons you might want to change the default HTTPS port 443, this can be done during the wizard.